blob: 3541e2732cf766645ad26c3cea287897960d63a1 (
plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
|
[pi3]
kernel=u-boot-rpi3.bin
[pi02]
kernel=u-boot-rpi3.bin
[pi4]
kernel=u-boot-rpi4.bin
enable_gic=1
armstub=armstub8-gic.bin
# Otherwise the resolution will be weird in most cases, compared to
# what the pi3 firmware does by default.
disable_overscan=1
# Supported in newer board revisions
arm_boost=1
[cm4]
# Enable host mode on the 2711 built-in XHCI USB controller.
# This line should be removed if the legacy DWC2 controller is required
# (e.g. for USB device mode) or if USB support is not required.
otg_mode=1
[all]
# Boot in 64-bit mode.
arm_64bit=1
# U-Boot needs this to work, regardless of whether UART is actually used or not.
# Look in arch/arm/mach-bcm283x/Kconfig in the U-Boot tree to see if this is still
# a requirement in the future.
enable_uart=1
# Prevent the firmware from smashing the framebuffer setup done by the mainline kernel
# when attempting to show low-voltage or overtemperature warnings.
avoid_warnings=1
# Enable GPU.
dtoverlay=vc4-kms-v3d
|
